So you want to put a ceramic coating on the exterior of your car? Well, you’ve come to the right place! Suma Performance is here to assist you in protecting your car’s paint, visit store to start your car painting journey and discover how their ceramic coatings can work wonders!
The easiest approach to keep a car looking fresh and retain its worth whenever the time comes to upgrade is to protect the paint. Ceramic coatings have quickly become one of the most popular paint-protection solutions on the market. It’s critical to do it properly the first time; else, you’ll wind up with a streaky mess.
Point is, your paint has to be protected. Here’s how to apply a ceramic coating properly so it stays looking brand new.
Step 1: Wash It Thoroughly
Extensively ringing the paint with a pressure washer is the first step. Then, using a foam cannon and snow foam, proceed to the pre-wash stage.
To clean the wheels, use a third bucket that is specifically for the wheels. Then, using safe wash procedures such as the two-bucket approach, wash the paint thoroughly.
The rinse water for washing the mitt is in one bucket, and the washing solution is in the other. Always begin cleaning at the top of your vehicle and work your way down to the bottom, as these are the dirtiest areas.
Step 2: Do A Chemical Decontamination
An iron filings and tar remover are typically used in the chemical decontamination stages. These products usually come in a clear spray can and change colour as they react. Allow for two to six minutes of low volume before it rains.
Similarly, lubricant for clay bars must be sprayed on the surface before rubbing the clay bar in all directions. It’s best to go easy on it; there’s no need to exert a lot of force. This process will aid in the removal of any impurities that have become entrenched in the ceramic coating.
Step 3: Polish The Pain
Because ceramic coatings are a semi-permanent coating, you must ensure that your paint is as smooth as possible before applying them to your vehicle. They seal any deformities which are left on the car’s exterior. As such, you’ll have to usually amplify the paint with a compound polisher.
A usual ceramic coating process needs the use of a number of different components. However, you will need to purchase a silica spray containing silica dioxide, the ceramic coating itself, a foam applicator block, and a microsuede application cloth.
Step 4: Apply The Ceramic Coating
Warp a micro-suede applicator with a foam block. Ensure that you give your ceramic coating container a good shake before using it. Then you’ll have to pour enough liquid to create a line on your microsuede, and then pour enough content to create a pattern on the microsuede.
Apply the ceramic coating using the microsuede in a crosshatch pattern, which means moving up and down and left to right, and working in tiny portions. work with the product in tiny parts and don’t leave it to dry for too long. The product will often flash after 20 to 30 seconds, indicating that it is ready to be removed with a high-quality soft microfiber cloth.